Raymond Mill safety precautions

[xuanxuan geng]

Some of our raymond mill operators still have a lot of dangerous habits when using machines. Today, Great Wall Heavy Industries has summarized the safety operations of some mill operators for the majority of mill operators. We hope that everyone will correct the situation and add to it.
1, check the belt, screws and the lubrication of the various parts before starting, you should remove the debris around the machine.
2. Place the raw material to be ground into the hopper and adjust the gap between the two grinding rolls. During the operation, the two ends of the grinding roll should be kept tight and the grinding should not be too tight. The line speed should not be too high.
3, when the milling operation, prevent the processing materials cut off. Before shutting down, the grinding roller must be detached to prevent direct contact between the two rollers. Always pay attention to the stock of the cylinder.
4, Raymond Mill processing materials must be screened. If the flat screen is blocked, gently tap it to avoid excessive force.
5, do not roll the roller too tight, grinding teeth can not be used too blunt to avoid excessive temperature. If a fire or explosion occurs, loosen the raymond mill roll immediately so that the abrasive flows down to extinguish the flame.
The above is the explanation of Great Wall Heavy Industry's attention to the operation of Raymond Mill. It is hoped that it can provide some reference suggestions for the pre-post training of the Raymond Mill operators of various enterprises, and also reminds the milling companies again, whether it is for the milling machine. The operator or the crusher operator must pay attention to the pre-service training of the operator.