Bentonite Ultrafine Mill Installed

[gjsohcat]

Raymond Mill is suitable for the preparation of various mineral powders and the preparation of coal powder, such as fine powder processing of raw materials such as raw materials, gypsum mines and coal. Then its accessories Raymond grinding roller in the use of operation methods need to pay attention to, the following small series for you to introduce in detail.

After the bentonite ultrafine mill is installed, it can be tested by hand-cranking and confirming that there is no jam. The test run should be carried out with a 2-4h no-load test and a 5-6h load test.

The higher the hardness, the more the number of carbides (Cr7C3) contained in the casting is required, the more dispersed the distribution, the greater the probability of micropores and microcracks forming at the interface between the matrix and the carbide, and the probability of fracture. The bigger. And the harder the item, the harder it is to cut. Therefore, casting a bentonite ultrafine mill fitting that is both wear-resistant and not easily broken is not as simple as imagined.